Jiujiang Deep Sea Technology Development Co., Ltd.

Sealant is also afraid of cold! How to apply it in low temperature?

Jan 07, 2025

 

07Winter sealant construction guide First, understand the curing principle of sealant. Common one-component silicone sealants and modified silicone sealants on the market are moisture-curing types. After extrusion, they will be exposed to moisture in the air and cure from the outside to the inside. The lower the ambient temperature and humidity, the slower the curing speed, and the thicker the colloid, the slower the curing of the inner colloid.

 

Suitable temperature construction

 

077

When the temperature is low, the wettability of the sealant and the substrate surface is reduced, and condensation and frost may occur on the substrate surface, affecting the adhesion. The recommended construction temperature range for sealants is 5-45 degrees Celsius, the construction temperature for structural adhesives is 10-40 degrees Celsius, and the humidity is 40%-80%. If special circumstances require construction below 5 degrees Celsius, an adhesion test must be carried out on site, and large-scale construction can only be carried out after passing the test. During construction, the substrate surface must be cleaned to ensure that the bonding surface is dry and clean, and the frequency of on-site rubber tapping inspections should be increased.

 

 

It is recommended to store sealant indoors

 

In winter, the extrudability of sealant is reduced, and it is normal for the sealant to feel heavier. Manufacturers will adjust according to the season. It is recommended that sealant be stored indoors during winter construction, and electric glue guns can be used if conditions permit.

 

Increase the ambient humidity and speed up the construction progress. Slow curing will affect the turning progress. The ambient temperature and humidity can be appropriately increased, but the glue application surface must be kept dry.

 

Avoid deformation caused by human touch. The slow curing of internal and external wall sealants will not have other adverse effects, but reminders should be made to avoid deformation caused by human touch.

 

It is necessary to confirm whether it can be cured normally before use. If the silicone adhesive product is stored at low temperature for too long, the curing condition should be confirmed after the temperature rises. If it can be cured normally and can be used normally within the shelf life, report any abnormality to the manufacturer in time.

 

 

Use quick-drying products or apply on cloudy days

When applying curtain wall joint sealant, bulging and deformation are prone to occur due to slow curing, especially for aluminum curtain walls and large-panel glass curtain walls. It is recommended to use quick-drying products, choose cloudy days for construction, or apply the sealant in two times.

 

Extend the maintenance time

In the construction of single-component structural adhesive, the uncured adhesive is in a closed state, and it is difficult for water to enter. The adhesive cannot be completely cured, and the curing time must be extended. The next step can be carried out after the rubber tapping test is qualified. You can also use a two-component silicone structural adhesive product. If the two-component structural adhesive is completely closed before curing, the strength will also be affected after curing.

 

When the cold wave hits, sealant is also afraid of the cold, but as long as you pay more attention, it can still perform effectively.

goTop