In the production of low viscosity end-side hydrogen (possibly hydrogen-containing silicone oil on the finger end), several details need to be taken care of to ensure product quality and production safety. Here are some key considerations
Raw material selection and ratio: Select suitable raw materials, such as dimethylcyclosiloxane mixed ring and tetramethyldihydrodisiloxane, and precisely control its ratio. This directly affects the degree of polymerization and viscosity of the product. At the same time, raw materials should be dried and dehydrated to avoid the impact of water on product performance.
Reaction condition control: During the reaction process, the reaction temperature and time should be strictly controlled. In general, the reaction temperature should be controlled at 40 ~ 60 ° C, stirring reaction time according to the specific situation, but to ensure that the reaction is fully carried out. In addition, the amount and time of addition of the catalyst need to be precisely controlled to optimize the reaction efficiency.
Batch adding and stirring: tetramethyldihydrodisiloxane can be added in batches, and a series of low polymerization degree and low viscosity hydrogen-containing silicone oil with controllable polymerization degree can be synthesized by adjusting its addition time and amount. During the addition process, it is necessary to maintain sufficient stirring to ensure that the raw materials are evenly mixed and the reaction proceeds evenly.
Filtration and removal of low boilers: After the reaction, the product needs to be filtered to remove impurities and to improve the purity of the product by removing the low boilers. This step is essential for obtaining high quality, low viscosity hydrogen-containing silicone oils.
Safety and environmental protection: In the production process, we must strictly abide by the safety operation procedures to prevent the occurrence of fire, explosion and other safety accidents. At the same time, we should pay attention to environmental protection and avoid the discharge of pollutants such as waste water and waste gas.
In summary, the production process of low-viscosity end-side hydrogen requires strict control of raw material selection and ratio, reaction conditions, batch addition and agitation, filtration and removal of low-boiling matter, safety and environmental protection and other details. Only in this way can we ensure product quality and production safety.

